Safety 1st Stair Gate Hold Open – STL

Safety 1st Stair Gate Hold Open – STL

This was designed to be used on the Safety 1st Auto-closing Stair Gate for those times that you actually don’t need it to be closed and what to hold it open.

Please keep in mind that once kids are around it is wise to remove it and get the gate closed again.

Printing instructions

You want this part to be robust so here is what I recommend:

• 0.2mm Layer Height
• 3 Perimeters
• 25% Infill
• Print on the position below to avoid delamination between layers while using.
• Supports are only needed for the start of the top inner edge, after that is 45degrees overhang so your printer will manage without supports.

Notes:

• This is not a physical product, it’s a virtual product.
• This is for personal use only. For commercial use, please contact me on the About me page.